Bottle Jack Extensions & Ram Adapters

We have all seen it! A shaky pile of mismatched blocks stacked up to get us close enough to use a bottle jack to lift an airplane. We have all been worried that the blocks would kick out and the jack would tip over dropping the airplane. That doesn’t have to happen anymore!

Jack Extensions are sized to slip over the ram of a bottle jack or hydraulic cylinder and extend the ram so the jack can sit firmly on the ground while the load is lifted. Several of the extensions can be stacked to extend the reach dramatically. Since the parts are all fit together, the jack is far safer and less likely to tip or otherwise fail.

The standard extensions have jack points machined into the top and they fit nicely on most 6 ton bottle jacks. Adapters are available to fit them to 12 ton or 20 ton bottle jacks. Specialty jack pads are available to lift against a variety of surfaces.